I can provide customized parameter lists and specific wiring diagrams for your setup. Share public link
This chapter lists warnings like:
A tabular list of fault codes. Example: | Fault Code | Description | Probable Causes (from manual) | Solutions | |------------|-------------|-------------------------------|------------| | ERR01 | Overcurrent during acceleration | Short circuit, acceleration time too short, motor stall | Check wiring, increase P0.15 (accel time) | | ERR05 | Overload (inverter) | Load too heavy, low voltage, wrong motor parameters | Reduce load, check P1 motor data | | ERR14 | Module overheat | Fan failure, dirty heatsink | Clean or replace fan | Invt CHE100 Inverter User Manualpdf
| Model | Capacity (kW) | Current (A) | Dimensions (W x H x D in mm) | |---|---|---|---| | CHE100-0R7G-2 | 0.75 | 4.5 | 85 x 140 x 115 | | CHE100-1R5G-2 | 1.5 | 7.0 | 120 x 180 x 140 | | CHE100-2R2G-2 | 2.2 | 10.0 | 120 x 180 x 140 | | CHE100-004G-2 | 4.0 | 16.0 | 160 x 250 x 175 | | CHE100-5R5G-2 | 5.5 | 21.0 | 160 x 250 x 175 |
| Inspection Item | Frequency | Criteria | |---|---|---| | Cooling fan operation | Monthly | Audible fan noise, unobstructed airflow | | Terminal tightening torque | Every 6 months | Loose connections cause overheating or intermittent faults | | Dust accumulation | Quarterly | Use compressed air (low pressure) to clean heatsink fins | | DC bus capacitor condition | Annually | Measured capacitance > 80% of rated value | | Input/Output voltage | Quarterly | Within rated tolerance (±15%) | | Ambient environment | Monthly | Temperature ( -10°C to +50°C), humidity (<90% non-condensing) | I can provide customized parameter lists and specific
| Group | Description | |---|---| | | Basic functions (control mode, command source, frequency source, acceleration/deceleration time) | | P1 Group | Start/stop control (starting frequency, DC braking, stop mode) | | P2 Group | Motor parameters (rated power, rated current, rated speed) | | P3 Group | Speed and torque regulation parameters (proportional gain, integral time) | | P4 Group | V/F control parameters | | P5 Group | Digital and analog input terminal functions | | P6 Group | Output terminal functions (relay, analog output) | | P7 Group | Display interface and password protection | | PC Group | Communication parameters (RS485 baud rate, parity, address) | | PD Group | Supplementary functions (oscillation suppression, torque control, etc.) |
Lists all P0–P9 parameter groups for fine-tuning. Troubleshooting: Provides error codes and solutions. 3. Installation and Wiring Guidelines Troubleshooting: Provides error codes and solutions
The is a family of sensorless vector control inverters, designed and manufactured by INVT (Shenzhen INVT Electric Co., Ltd.). Market positioning of this series focuses primarily on OEM clients in the middle and low-end market segments, offering an optimal balance between performance and cost.
Input power terminals (3-phase 380V). For single-phase 220V units, use L and N .