Ericsson Mini Link Cli Commands Today

Triggers an IF/RF loopback facing the antenna to verify the local outdoor unit (ODU/RAU). set radio-link loopback off Use code with caution.

alarm threshold rsl 1 low -60 high -30

: Enabled by the enable command. This mode allows configuration changes . ericsson mini link cli commands

The Ericsson MINI-LINK family (including MINI-LINK TN, CN, and PT series) is the backbone of modern mobile transport networks, providing high-capacity microwave and millimeter-wave backhaul. While the Element Manager (EM) and Network Manager (NM) offer graphical interfaces, the Command Line Interface (CLI) remains the most powerful, granular, and scriptable tool for installation, troubleshooting, and maintenance.

boot system flash:<imagefile>

show version : Outputs the active software release, standby software release, and bootloader versions.

enable : Used to raise the privilege level to , which allows configuration changes. Triggers an IF/RF loopback facing the antenna to

reboot