Galaxy Aqua Premier Installation Manual Jun 2026

: Connect from the flow restrictor outlet on the system to the quick-connect fitting on the drain saddle. Step 5: System Start-Up and Flushing

If you are not a qualified electrician or plumber, hire a certified professional to complete the connection phases. Technical Specifications and Requirements

Empty tank and check pressure with a gauge; calibrate to 7-5 PSI. Faulty Auto Shut-Off (ASO) valve

If you need to customize your system or ensure ongoing performance, let me know. I can provide the , explain how to integrate a three-valve bypass loop , or outline seasonal maintenance tips for vacation homes. Share public link

Install the system indoors. Do not expose the unit to freezing temperatures or direct sunlight, which can weaken the plastic housing. galaxy aqua premier installation manual

Strip back the outer insulation safely without nicking the copper conductors.

Ensure the internal control dials match the positioning alignment pins on the front cover.

: This report is a synthesized informational document. Always cross-check with the official Galaxy Aqua Premier manual that accompanied your product, as design revisions occur. Contact Galaxy Aqua technical support for model-specific bulkhead sizes, pump flow curves, or replacement part numbers.

Let water run through the faucet for 10 to 15 minutes. The water may look black or cloudy at first; this is normal carbon dust clearing out. : Connect from the flow restrictor outlet on

Before turning on the power, turn on the water supply and allow it to flow through the unit to clear any air pockets. Check for Leaks:

Maintain an air gap of at least 1 inch to prevent backflow contamination. Step 4: Initial Flushing and Setup

The Galaxy Aqua Premier manual emphasizes that failure to bond the pump to a grounding system voids the UL/ETL safety certification and can lead to stray voltage in the water, harming aquatic life and users.

: 100kPa (1.0 bar / 15 psi) at a flow rate of 9 litres/minute for the 9.5kW model. Maximum Static Pressure : 1000kPa (10 bar / 150 psi). Electrical Supply : Mains supply must be 230/240V at 50Hz The unit requires a double pole switched fused connection unit with a minimum 3mm contact separation gap. It is strongly recommended to fit a 30mA Residual Current Device (RCD) National Shower Spares Installation Steps Preparation : Plan the installation near the rising main. Ensure an isolating valve is fitted in the water supply for future servicing. Remove the cover screws and the front cover. Faulty Auto Shut-Off (ASO) valve If you need

Let the storage tank fill completely (this typically takes 45 to 60 minutes).

Connect the supply pipe to the shower’s internal inlet valve using a 15mm compression elbow. Use PTFE tape to ensure a watertight seal.

Once the water runs perfectly clear, close the faucet and open the storage tank valve.

: Limescale or debris in the balancing valve can cause temperature instability. Standard maintenance includes cleaning the inlet filter and the internal adjuster pin.

For detailed diagrams and part numbers (like the Thermal Cut-Out or Flow Switch), you can view specific guides on sites like The Shower Doctor or download similar fitting instructions from Hygiene Supplies Direct , such as a leak or no hot water? Galaxy Aqua Premier Water Heater 9.5Kw - 45793266

Are you writing this for a (e.g., 8.5kW vs 9.5kW)? Share public link