Kincaid Radio Controlled Clock Instruction Manual Direct

Your Kincaid clock automatically adjusts for DST in spring and fall. If you live in a region that does not observe DST (Arizona, Hawaii, Saskatchewan):

| Icon | Meaning | Status | |------|---------|--------| | Radio tower icon | Signal reception | Solid = synced; Flashing = searching; Off = no signal | | Battery indicator | Low battery | Replace batteries when this appears | | DST | Daylight saving time | Automatically adjusts where applicable | | Alarm icon | Alarm active | Only on models with alarm function |

The hour digits will begin to flash. Use the UP/DOWN or ADJUST buttons to change the hour. Press SET again to move to minutes, year, month, and date. kincaid radio controlled clock instruction manual

💡 If you are placing the clock in a location with historically poor reception, some clocks allow you to move it to a window for the nightly synchronization and then return it to its final position.

Press and hold the SET (or M.SET) button for 3+ seconds . Adjust Hands: Hold the button to move the hands quickly. Your Kincaid clock automatically adjusts for DST in

If you are outside the standard signal range or the signal is weak, you may need to set the time manually: Enter Manual Mode : Press and hold the ) button on the back for approximately 3 seconds. Adjust Time Press and hold the button to fast-forward the hands.

Issue: The hands are spinning continuously or frozen at 12:00. Press SET again to move to minutes, year, month, and date

Use the or DOWN / - buttons to adjust the flashing value.

Activates the backlight or pauses an active alarm for 5 minutes. Manual Time and Date Programming

Before your Kincaid clock can receive the radio signal, you must perform a basic manual setup to establish the hands' reference position.