This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The EZP2020 is a USB 2.0 interface programmer capable of transfer speeds up to 12Mbps. It supports various chip series, including 24/25/93 series EEPROM, SPI Flash, and even some microcontrollers. Its key applications include:
Click "Next". If prompted with a security warning, select . Phase 4: Setting Up the Interface (English) ezp2020 programmer software download install
The bottom status bar should say or "Ready" . If it says "Disconnected", the driver did not install correctly.
Before installing, understanding your hardware helps prevent errors during the flashing process: USB 2.0 (high speed up to 12 Mbps) This public link is valid for 7 days
The interface should load, and the status bar at the bottom should say "Connected" or "Ready." 4. Key Features of the EZP2020
Follow these steps to ensure the hardware and software communicate correctly. Step 1: Extract the Files Download the .zip or .rar archive. Extract it to a dedicated folder (e.g., C:\EZP2020 ). Avoid running the software directly from the zipped folder. Step 2: Install the USB Drivers Connect the EZP2020 programmer to your USB port. Open (Right-click Start > Device Manager). Look for an "Unknown Device" or "USB Serial Port." Can’t copy the link right now
Installing the wrong software can "brick" the device (until drivers are manually fixed) or cause verification errors.
Click Read , wait for the progress bar to finish, and then click Save . Keep this original dump safe in case you need to revert.
Once installed, follow these steps to ensure the programmer is working: Open the EZP2020.exe .
The USB driver is installed as a serial port, not a programming interface. Use Zadig to switch to WinUSB or libusb-win32 .