Scrap away any paint or oxidation around the pad area if necessary to expose bare metal.
For detailed and platform-specific commands, always refer to the official "Nokia SR Linux Configuration Guide" and "Nokia 7250 IXR Hardware Installation Guide" available on the Nokia documentation portal.
Avoid tight cable bends; maintain a minimum bend radius of 1.2 inches (30 mm) for fiber cables to prevent signal attenuation. 6. Initial Configuration and Verification
Connect the provided RJ-45 to DB-9 console cable to the port labeled CONSOLE or MGMT on the front panel. Connect the other end to your terminal server or management laptop. nokia 7250 ixr x1 installation guide
This guide focuses on the clean installation procedure.
Open a terminal emulation program (e.g., PuTTY, Tera Term) on your connected laptop. Use the standard serial settings: Baud rate: 115200, Data bits: 8, Parity: None, Stop bits: 1, Flow Control: None .
[Optic Module] ---> [SFP+/QSFP Port] ---> Click! [Fiber Cable] ---> [Optic LC Bore] ---> Click! Installing Optical Transceivers Scrap away any paint or oxidation around the
Insert rack screws through the mounting ear holes and into the rack rails.
Inspect the chassis for any visual signs of transit damage. If you notice structural damage or missing components, contact your Nokia logistics representative immediately. 3. Mechanical Installation and Rack Mounting
Insert the AC power cord into the appliance inlet on the PSU. This guide focuses on the clean installation procedure
When prompted for login credentials, enter the factory default username and password (typically admin / admin or as specified in your shipment's release documentation).
Remove the dust cap, clean the fiber-optic connector using an approved optical cleaning tool, and insert the cable into the transceiver. Management and Console Cabling
Once powered up, you can populate the interface slots based on your architectural design. Installing Transceiver Modules