Press the same buttons again until the icon disappears. Daylight Saving Time (DST)

To program additional events (e.g., 2_ON, 2_OFF), press again and repeat the steps.

Before first use or after a long period of inactivity, the timer’s internal memory backup battery must be charged. Charge Time : Plug the timer into a standard wall outlet for 12–14 hours : After charging, use a pin or paper clip to press the "R" (Reset) button to clear any old data. Setting Current Time & Day Enter Mode : Press and hold the button for 3 seconds. Adjust Values + and - buttons to adjust the hour, minute, and day. to lock in each setting and move to the next. Programming On/Off Cycles The EW-32 supports up to 10–20 different programs. Access Programming : Press the once to enter program mode (displaying "P1"). Select Program to choose a program number (e.g., P1, P2). Set "ON" Time , then use

: Use a sharp object (like a pen) to press the RESET button to clear all current settings and restore factory defaults. Setting the Current Time

The remains a robust and accurate timing solution for countless industrial applications. However, its full potential is only unlocked with the correct documentation. Your primary mission should be securing the official chevron digital timer ew-32 pdf from a trusted source—whether from a distributor, an archived manufacturer page, or a vetted manual library.

What are you trying to automate?

| | Likely Solutions | | :--- | :--- | | Display is Blank | If it's a rechargeable timer, ensure it has been plugged in and allowed to charge for at least one hour. Also, verify the wall outlet is working by testing it with another device. | | Timer Not Following Schedule | 1. Confirm the timer is in AUTO mode, not ON or OFF . 2. Double-check that the AM/PM settings are correct for both the current time and your programmed times. 3. Make sure the connected device is powered on. | | Trouble Setting AM/PM | When setting the hour, cycle through the full 12-hour cycle, carefully watching the display for a small "AM" or "PM" indicator to confirm the correct setting. |

: The outlet stays continuously powered on, ignoring all programmed schedules.

If you are using the device for the first time, plug it into a live wall outlet for 30 minutes to charge the internal backup battery. Step 1: System Reset

Match the wires from the Chevron EW-32 timer to your wall box wires using wire nuts: from timer →right arrow Line (Hot) wire from wall box. Red wire from timer →right arrow Load wire from wall box. White wire from timer →right arrow Neutral wire from wall box. Green wire from timer →right arrow Ground wire from wall box. Step 4: Secure the Switch

Chevron Digital Timer EW-32 is a 24-hour/7-day programmable plug-in timer designed for home automation and energy saving. It allows you to schedule electrical devices like lamps and heaters to turn on and off automatically. Preparation Initial Charging

The Chevron Digital Timer EW-32 (often referenced similar to 7-day electronic timers, such as those found at Sparks Direct ) is a plug-in device designed to turn connected appliances on and off based on a user-defined schedule.

: Press PROG again. You will see "1 OFF." Repeat the DAY, HOUR, and MIN steps to set when the device should turn off. Exit : Press CLOCK to save and return to the main display. 3. Manual Override Modes

Remove the wall plate screws and pull the old switch out of the wall box. Disconnect the wires from the old switch. Step 2: Identify Your Wires