Free ^hot^ Resetter Canon Service Tool V320032 Fixed Jun 2026

While keeping the Power button pressed, press the button 5 times consecutively. Release the Power button.

Before launching the software, you place your printer into Service Mode . The tool will not work otherwise. Turn off the printer.

When you see the term "Free Resetter Canon Service Tool V320032 ," it refers to a modified or patched version of the original software. The original Service Tool might have had certain bugs, limitations, or incompatibilities that prevented it from working correctly on specific printer models or Windows operating systems.

: Checks nozzle alignment and printer health directly through the tool.

Which are you running the tool on? Share public link free resetter canon service tool v320032 fixed

Canon designed your printer to shut down after a certain number of purges, forcing you to either pay for costly service center repairs or buy a new printer.

To use the tool effectively, the printer must first be placed into . Enter Service Mode : Turn off the printer but keep it plugged in.

Inside the tool, check the "USB Port" number. If it says "0," the printer is not in Service Mode. Reset Ink Absorber: Locate the Ink Absorber Counter section. Set the Absorber field to "Main". Set the Counter Value to "Main_Left" (or "0"). Click the Set button next to it.

Turn the printer back on normally. Your error code should be gone, and the printer is ready for standard use. Troubleshooting Common Errors During the Reset While keeping the Power button pressed, press the

Canon printers contain sponge-like pads that collect waste ink during cleaning cycles, borderless printing, and startup. To prevent ink from spilling over and damaging the printer, Canon set a limitation in the firmware. Once the internal counter hits 100%, the printer locks down.

The software is open, but the printer is not successfully in Service Mode.

While holding Power, release Stop and then press it (the light should cycle between green and orange).

Over the years, multiple versions of the Service Tool have been released (v2000, v3000, v3200, v3400). Version 320032 is specifically compatible with many budget and mid-range Canon printers released between 2015 and 2020. The tool will not work otherwise

This is almost always a . The reasons are technical:

The Canon Service Tool is an unofficial (but widely trusted) software application designed to communicate directly with your Canon printer's EEPROM (Electrically Erasable Programmable Read-Only Memory). This chip tracks internal counters, including the waste ink pad counter.

Note: For much newer Canon G-series (MegaTank) or TS-series models, a newer iteration of the service tool (such as v5103 or v5320) may be required. Troubleshooting Common Errors During Reset

If you attempt to open the Service Tool before entering Service Mode, or if you use an unverified/corrupted version of the software, you risk permanently locking or "bricking" the printer's mainboard IC chip. Always follow the hardware button sequence first before executing the software. Important Safety Warning Regarding Hardware

To reset the 5B00/5B01 error codes, particularly on older or specific Chinese models like MP288, Pixma MG Series, and G Series. Supported Canon Printers