Connect a short coaxial cable from the LNB on your dish to the port labeled "TO LNB" on the RV3.
Connect a coaxial cable from your satellite dish LNB to the "TO LNB" port on the bottom of the RV3.
Turn your receiver on. The RV3 will light up, drawing power through the coaxial cable. 4. Step-by-Step Alignment Process Step A: Initial Positioning deutsche technologies rv3 digital satellite finder manual
A transponder is the specific frequency on a satellite. You must input the correct parameters for your desired channels.
The satellite receiver is turned off or not sending power. Connect a short coaxial cable from the LNB
Connect your satellite dish LNB to the "LNB IN" port on the top of the meter using a coaxial jumper cable.
Once you find the peak signal position horizontally, lock the azimuth bolts loosely. Next, gently adjust the elevation tilt up and down by fractions of an inch until the meter reaches its highest possible numeric value. Finally, rotate the LNB slightly (skew adjustment) to maximize the quality percentage indicator. Step 5: Final Lock and Disconnection If the signal goes to The RV3 will light up, drawing power through
Ensure your device is never used in rainy or snowy conditions to prevent liquid damage. Additionally, always ensure no short circuits are created when connecting the coaxial cable to the LNB.
Press the or ATT+ buttons to adjust the internal attenuation until the signal strength reading sits comfortably around 30% to 50% .
Select the target satellite (typically for Australian services). Dish Alignment:
VCDS автосканер для ВАГа © 2025