V2000-c Rfid Access Control User Manual |best| Jun 2026

The Green LED will turn solid or flash to indicate active programming mode. Step 2: Modifying the Default Admin Code

999999 (or sometimes 888888 depending on production batch).

To configure the unit, you must enter programming mode: * → [Master Code] → # (The yellow LED will light up, indicating you are in programming mode) . 4.2 Changing the Master Code Enter Programming Mode: * 123456 # Press 0 → [New 6-digit Master Code] → # Repeat [New 6-digit Master Code] → # Exit: * 4.3 Adding Users (Cards or PINs) Enter Programming Mode. Press 1 → [Read Cards] → # → * Add PIN Only: Enter Programming Mode. Press 1 → [Enter 4-6 digit PIN] → # → * 4.4 Deleting Users Delete a Card: Enter Programming Mode. Press 2 → [Read Card] → # → * Delete by PIN: Enter Programming Mode. Press 2 → [Enter PIN] → # → * 4.5 Setting Door Relay Time To adjust how long the door stays unlocked: Enter Programming Mode. Press 4 → [0-99 seconds] → # → * 5. Troubleshooting & Tips V2000-c Rfid Access Control User Manual

| Feature | Specification | | :--- | :--- | | Operating Voltage | DC 12V (±2V) | | Standby Current | < 35mA | | Open Current | < 150mA | | Card Type | EM (125KHz) / Mifare (13.56MHz) | | User Capacity | 1,000 cards / 1,000 PINs | | Output Relay | Dry contact (NO/NC/COM), max 2A/30VDC | | Working Temp | -20°C to +60°C | | IP Rating | IP65 (weatherproof) |

Complete Guide and User Manual for the V2000-C RFID Access Control System The Green LED will turn solid or flash

Issue 2: Card swiped, light turns green, but lock does not open

Normally Closed relay contact (used for fail-safe magnetic locks) Press 2 → [Read Card] → # →

This manual serves as a definitive resource for physical setup, initial programming, wiring layouts, and regular administration. Users looking to save a copy can access the official Obohands V2000-C Product Downloads for direct digital documentation. 1. Technical Specifications and Hardware Overview

This method creates a user that requires both a valid card and its corresponding 6-digit PIN to gain access.

This is your first task. Do not skip.

Connect Power Supply (GND) to Keypad GND and Lock (-). Fail-Secure Lock (e.g., Electric Strike)